Faucet Installation - Kohler 103B86-SANA-CP Guia De Instalacion

1. Faucet Installation

NOTE: Before drilling the mounting hole, use the following
dimensions for proper placement:
A 1-1/4" (32 mm) minimum to 1-1/2" (38 mm) maximum
diameter mounting hole is required.
A minimum distance of 1-3/4" (44 mm) is required between the
back of the spout and the wall to allow access to the screw.
A 1-1/8" (29 mm) maximum distance is required between the
sink bowl edge and the base of the spout.
Install the Faucet
Determine the mounting-hole location.
Drill a hole through the mounting surface according to the
surface manufacturer's instructions.
Insert the spout with flexible hoses and studs through the
mounting hole.
From under the sink, slide the rubber washer and metal washer
onto the studs.
Thread the nuts onto the studs and wrench-tighten to secure the
faucet to the mounting surface.
1386432-2-A
Rubber Washer
Metal Washer
Nuts
Water Inlet Hose
4
Sensor
Kohler Co.