Faucet Installation - Kohler K-12185 Guia De Instalacion

Handspray
Spray
Holder
Apply
plumbers
putty.
Sink
Nut
Hose
1. Install the Handspray
Apply a bead of plumbers putty or other sealant to the underside
of the spray holder according to the manufacturer's instructions.
Insert the spray holder through the sink hole.
Securely hand tighten the nut from under the sink.
Remove any excess putty or sealant.

2. Faucet Installation

Slide the escutcheon and gasket to the spout.
Partially thread two screws into the threaded ring until they
protrude slightly from the backside of the threaded ring.
Run the handspray hose down through the handspray holder.
Slide the threaded ring and washer on the handspray hose.
Run the handspray hose up through the spout mounting hole and
attach it to the handspray hose connector on the spout.
Position the spout in the desired mounting position.
Slide the metal washer onto the shank.
Thread the ring up the shank until it is about 1/4" (6 mm) away
from the underside of the sink. Ensure the screw holes face the
front and back of the faucet.
Tighten the screws.
Kohler Co.
Spout
Escutcheon
Handspray
Hose
Connector
Gasket
Washer
Ring
Screws
Spray Hose
3
Sink
1036180-2-C