Faucet Installation - Kohler K-6330 Instrucciones De Montaje

Install valve to
right or left of
spout.
Water
Supplies
Drain Line
Pulley Cover
1. Supply Installation
NOTE: This spout and valve can be installed from 4" (10.2 cm) to 8"
(20.3 cm) between center-to-center.
NOTE: The water supply lines must be offset to the right or left as
shown to avoid interference with the pulley cover.
Install the water supplies and drain line according to the
illustration.
Flush the water supplies and stops.

2. Faucet Installation

Install the rubber gasket to the underside of the valve.
Fit the valve through the desired sink hole.
Position the valve so the handle faces forward.
Thread two screws into the threaded ring until they barely
protrude from the top of the threaded ring.
Fit the fiber washer and metal washer to the valve shank.
Install the threaded ring to the valve shank until the threaded
ring is just touching the sink.
Turn the threaded ring so the screws are to the front and back of
the faucet.
Securely tighten the screws.
Kohler Co.
Valve
Inlet
Sink
Metal Washer
Fiber Washer
Threaded Ring
3
Valve
Shank
Rubber
Gasket
Screw
1025493-2-B