WASHING WITH INJECTION-VACUUMING SY-
STEM
Preparation:
- Fit filter (X) under the head (A) (fig. 11)
- Pour the detergent product into the solution
tank (U) (fig. 12).
- Fit the vacuum head (A) on the shaft (I) and
tighten with fasteners (G) (fig. 8).
- Fit the hydraulic pipe (Y) in solution tank (U)
(fig. 13)
- Fit the flex hose (L) into the vacuum opening
(H) (fig. 9).
- Fit the end of the hydraulic pipe (E) on the
quick coupling on head (fig. 14).
- Fit accessory (D) in the end of flex hose (L), or fit
the extensions (M) with accessories (C and T)
- Secure the hydraulic hoses with the clips (fig. 2).
•
Never use the appliance without a filter!
Use:
- Connect the device to a suitable electrical
outlet.
- Press the lever on the tap (Q) (fig. 15) and both
the switches (F) (B) (fig. 10).
Hold the lever down and wait for detergent
to come out.
- To go ahead and wash, place the accessory on
the surface and, pressing the lever of tap, pull it
towards you.
- After completing the operation, turn off
switches (F) and (B) (fig. 10).
Do not leave the pump running with no deter-
gent in the tank or without dispensing detergent
for more than 5 minutes, to prevent damaging the
pump.
CARE AND MAINTENANCE
The unit is maintenance-free.
•
T he machine shall be disconnected from its
power source, by removing the plug from the
socket-outlet, during cleaning or maintenance
• Clean the exterior part of the machine with a
dry cloth.
• Move the appliance only by catching the
carrying handle located on the motor head.
• Store the appliance and the accessories in a dry
safe place, out of the reach of children.
FILTER CLEANING (S2)
1- Remove the filter
2- wash tge filter
3- Let the filter drying befor reassemble it
•
O nce the filter has been cleaned, check
whether it is suitable for further use. If it has
been damaged or broken, replace it with an
original filter.
WARRANTY CONDITIONS
All our machines are subjected to strict tests and
are covered against manufacturing defects in accor-
dance with applicable regulations. The warranty is
effective from the date of purchase.
The following are not included in the warran-
ty: - Parts subject to normal wear. - Rubber parts,
charcoal, filters and the accessories and optional
accessories. - Accidental damage, caused by tran-
sport, neglect or inadequate treatment, incorrect or
improper use and installation failing - The warranty
shall not cover any cleaning operations to which the
operative components may be subjected, such as
clogged nozzles and filter blocked due to limesto-
nes. This pressure cleaner is intended to be used for
domestic and hobby work: the warranty does not
cover any other different kind of use.
DISPOSAL (WEEE)
As the owner of electrical or electronic
equipment, the law (in accordance with the EU Di-
rective 2002/96/EC of 27 January 2003) prohibits
you from disposing of this product or its electrical /
electronic accessories as municipal solid waste and
obliges you to make use of the appropriate waste
collection facilities.
The product can be disposed of by returning it to
the distributor when a new product is purchased.
The new product must be equivalent to that being
disposed of.
EN
9