for any damage/injury caused to persons,
animals or property caused by misuse of the
appliance, not in compliance with manual
instructions.
HOW TO PREPARE AND USE THE ELEC-
TRIC ASH VACUUM CLEANER
(fig. ① ② ③).
• Make sure the filter F is fitted in its housing .
• Connect the steel pipe C to its fitting E .
• B efore vacuuming the ash, check that it is
cold and no longer alight.
Do not vacuum burning embers
• D o not empty the drum into a container
which is easily inflammable and make
sure that the ashes are completely cool.
• If ashes hose C becomes hot during use, turn
the device off immediately and let it cool.
• Turn the appliance on using the (I)ON/(0)OFF
switch, located on the cover of the motor.
• Vacuum the ash directly from the fireplace
or from the stove (wood or pellet-burning).
Hold the suction nozze about 1 cm. above
the ash.
(see fig. ④) If there should be a reduction in the
suction power, turn the motor off using the
switch and, when the motor is completely
still, operate the filter reset lever T several
times to reset the filter . To do this, pull out
the knob fully and then release it sharply so
that it shakes the filter inside the appliance.
Now, turn the appliance on once again using
the switch and check the suction power. It
is advisable, in any case, to clean a max. of
2/3 Kg of ash (wood or pellets) during each
cleaning operation. Operate the filter reset
lever, before each cleaning cycle.
• When the appliance is no longer in use, turn
it off and take the plug out.
• When the stove or fireplace has been cleaned,
the appliance and suction filter must then be
cleaned .
CARE AND MAINTENANCE
The unit is maintenance-free.
• T he machine shall be disconnected from its
power source, by removing the plug from the
socket-outlet, during cleaning or maintenance
• Clean the exterior part of the machine with a dry
cloth.
• Move the appliance only by catching the car-
rying handle located on the motor head.
• Store the appliance and the accessories in a
dry safe place, out of the reach of children.
FILTER CLEANING
(see fig. ⑤)
• T he machine shall be disconnected from its
power source, by removing the plug from the
socket-outlet, during cleaning or maintenance
1- Remove the filter F
2- Shake the filter F
3- wash tge filter F
4- Let the filter F drying very well ,befor reas-
semble it
• O nce the filter has been cleaned, check
whether it is suitable for further use. If it has
been damaged or broken, replace it with an
original filter.
WARRANTY CONDITIONS
All our machines are subjected to strict tests and
are covered against manufacturing defects in accor-
dance with applicable regulations. The warranty is
effective from the date of purchase.
The following are not included in the warran-
ty: - Parts subject to normal wear. - Rubber parts,
charcoal, filters and the accessories and optional
accessories. - Accidental damage, caused by trans-
port, neglect or inadequate treatment, incorrect or
improper use and installation failing - The warranty
shall not cover any cleaning operations to which
the operative components may be subjected, such
as clogged nozzles and filter blocked due to lime-
stones.
This pressure cleaner is intended to be used for do-
mestic and hobby work: the warranty does not cover
any other different kind of use.
DISPOSAL (WEEE)
As the owner of electrical or electronic
equipment, the law (in accordance with
the EU Directive 2002/96/EC of 27 January 2003)
prohibits you from disposing of this product or
its electrical / electronic accessories as municipal
solid waste and obliges you to make use of the
appropriate waste collection facilities. The product
can be disposed of by returning it to the distributor
when a new product is purchased. The new product
must be equivalent to that being disposed of.
Acoustic pressure Lpa 75 db (A)
9
EN