Remote Control Operation; Normal Operating Mode; Auto Mode - Infiniton AP-260 Manual De Usuario

REMOTE CONTROL OPERATION

All the controls on the machine control
panel are replicated on the remote control
unit with the addition of the Auto-Mode (J).
Press this button to select AUTO-MODE.
When the Air Quality indicator flashes, the
filters are becoming blocked and need
replacement.
(See Maintenance on pages 17-19). After
replacing all the filters, press the RESET
button (K) on the remote control for 2-
seconds and the filter service interval time
will be re-set.
OPERATING MODES
When the appliance is first plugged in, you will hear a beep, indicating that the
appliance is operating normally.
If required, set the appliance running at high speed for fast initial cleaning of the air
before adjusting the control to a slower speed.

NORMAL OPERATING MODE

When the appliance is on, it will enter the NORMAL operating mode by default. press
the fan speed button (H, M, L, SILENT) as required. The operating status will be as
follows:
. Press the fan speed button to adjust the fan speed as required, the related fan
speed light will be on.
.The Plasma function will be operating by default. Press the 'PLASMA' button to
set the plasma function on or off.
.The Air Quality indicator will be on by default. Press the 'AIR QUALITY' button to
set the Air Quality indicator on or off.

AUTO MODE

Set the appliance in Auto mode by using the "AUTO" button in the remote control.
. The high, mid, or low fan speed indicator will all flash in turn, showing that the
appliance is running in AUTO mode.