Infiniton AP-260 Manual De Usuario página 31

benefit of people with allergies or asthma. When it is set to a higher sensitivity level,
the appliance starts cleaning the air at lower pollution levels to make the air cleaner.
There are four sensitivity levels:
.Common
.Standard
.Sensitive
.Extra Sensitive
The pollution sensor is set to 'standard' sensitivity but you can adjust the sensitivity of
the air quality sensor in the following way:
1.If the appliance is already plugged in, unplug and wait for a few minutes, before
plugging back in.
2.In STANDBY mode, press AIR-QUALITY + HIGH-SPEED buttons. After the buzzer
sounds twice, the air quality sensor sensitivity has been set to extra sensitive.
This should be indicated by the corresponding indicator flashing five times and
confirmed immediately after pressing the power button to turn on the appliance.
3.In STANDBY mode, press AIR-QUALITY+MID-SPEED buttons. After the buzzer
sounds twice, the air quality sensor sensitivity has been set to sensitive level.
4.In STANDBY mode, press AIR-QUALITY+LOW-SPEED buttons. After the buzzer
sounds twice, the air quality sensor sensitivity has been set to standard level.
5.In STANDBY mode, press AIR-QUALITY+SILENCE buttons. After the buzzer
sounds twice, the air quality sensor sensitivity has been set to common level.
.The sensitivity level can be confirmed by the corresponding indicator flashing
five times immediately after pressing the power button to turn on the appliance.
NOTE: The appliance automatically starts operating at the pre-set
sensitivity level when switched on again.
SENSITIVITY SETTING INQUIRY
In STANDBY mode, press the air quality indicator button to check the sensor
sensitivity setting. Exit after the corresponding sensitivity indicate light flashes five
times or exit by pressing other buttons (except for the reset button).
MAINTENANCE
!
WARNING: ALWAYS UNPLUG THE APPLIANCE BEFORE PERFORMING ANY
CLEANING OR MAINTENANCE OPERATIONS.