Replacing The Filters; Resetting The Appliance - Infiniton AP-260 Manual De Usuario

REPLACING THE FILTERS AND RESETTING THE APPLIANCE

REPLACING THE FILTERS

Remove and re-fit the filters as shown on page 10.

RESETTING THE APPLIANCE

1.After filter replacement, plug in and turn back on.
. The 'Power On' sound will be heard when the appliance reaches STANDBY
status.
2.Press the RESET button on the hand controller for 2 seconds. When the buzzer sounds
once, the service scheduling of the filters has been cleared and re-set. The Air Quality
light will be ON, indicating that the re-set has been successful.
NOTE: The RESET button at the Air Quality Sensor inlet can clear the filter
service schedule and restart it at any time. Do not press the Reset button
when the filter replacement light is not flashing.
NOTE: Only replace the filters when the 慉 ir Quality?light flashes. If you
replace the filters before the 慉 ir Quality?light starts flashing, the
service schedule will not be reset but will continue counting the lifetime
of the previous filters. As a result, the 慉 ir Quality?will start flashing
and the appliance be locked off far too soon.