RIDGID R4030 Manual Del Operador página 14

ASSEMBLY
TILE CUTTING WHEEL
For maximum performance and safety, it is recommended
that you use the 7 in. cutting wheel provided with your
saw. Additional cutting wheels of the same high quality are
available at your local dealer.
WARNING:
Do not use cutting wheels rated less than the no
load speed of this tool. Failure to heed this warning
could result in personal injury. Do not use wheel
with cracks, gaps, or teeth.
INSTALLING THE TILE CUTTING WHEEL
See Figure 11.
WARNING:
A 7 in. tile cutting wheel is the maximum wheel
capacity of the saw. Never use a wheel that is too
thick to allow wheel washer to engage with the
flats on the spindle. Larger wheels will come in
contact with the splash hood, while thicker wheels
will prevent the wheel bolt from securing the wheel
on the spindle. Either of these situations could
result in a serious accident and can cause serious
personal injury.
 Unplug the saw.
 Place the wheel wrench on the arbor nut then slide the
arbor wrench into the arbor.
ARBOR
WATER
NOZZLES
TILE CUTTING
WHEEL
OUTER
INNER
WASHER
WASHER
ARBOR
Fig. 11
 Holding the arbor wrench firmly to prevent movement,
pull the wheel wrench (left side) forward to the front of
the machine to loosen.
 Remove the arbor nut and outer washer leaving the inner
washer on the arbor.
WARNING:
Always install the inner wheel washer before
placing wheel on arbor. Failure to do so could
cause an accident since the wheel will not tighten
properly. Never use wheels that have openings,
grooves, or teeth on this tool.
 Place the cutting wheel onto arbor with the arrows on
wheel going in the counterclockwise direction.
 Replace the outer washer. The double "D" flats on the
washers align with the flats on the arbor.
 Replace the arbor nut on the arbor. Using wheel wrench
and arbor wrench, tighten arbor nut securely.
NOTE: Two water nozzles come installed on this product.
The hole in each nozzle should face the cutting wheel.
INSTALLING THE MITER GUIDE
See Figure 12.
The miter guide can be used from both the left and right side
of the cutting wheel.
 Place the slot on the underside of the miter guide on the
sliding table fence.
 Lock the miter guide securely to the table by turning the
lock knob clockwise.
To adjust angles:
 Loosen the miter knob.
 Rotate to the desired angle by moving the guide left or
right.
 Tighten the knob securely before turning on the saw.
NUT
45
14 — English
MITER
KNOB
MITER
GUIDE
SLOT
LOCK
KNOB
Fig. 12