Features; Assembly; Operation - RIDGID R8831 Manual Del Operador

FEATURES

PRODUCT SPECIFICATIONS
Strokes per minute .......................................... 0-2,050 SPM

ASSEMBLY

WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and
completely assembled or with damaged or missing
parts could result in serious personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.

OPERATION

WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
tool. The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Cutting all types of wood and wood products, thin sheet
metal, plastics, and laminates
WARNING:
Battery tools are always in operating condition.
Therefore, the switch should always be locked
when not in use or carrying at your side.
Stroke Length ............................................................... 1 in.
WARNING:
Do not attempt to modify this product or create
attachments or accessories not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
STARTING/STOPPING THE SAW
See Figure 2, page 9.
The trigger lock prevents the saw from accidental starting.
The switch trigger cannot be depressed until the trigger lock
is depressed.
To turn the saw ON, depress the trigger lock button and
pull the switch trigger. Release the switch trigger to turn
the saw OFF.
NOTE: The trigger lock button can be depressed from either
side. The trigger lock automatically resets when the switch
trigger is released.
INSTALLING/REMOVING BATTERY PACK
See Figure 3, page 9.
To install:
 Insert the battery pack.
 Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
product before beginning operation.
To remove:
 Depress the latches on each side of the battery pack.
5 – English