Maclaren VOLO Manual Del Usuario página 10

Ocultar thumbs Ver también para VOLO:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
EN
Instructions
• READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP THEM FOR FUTURE REFERENCE.
IMPORTANT:
• YOUR CHILDREN'S SAFETY MAY BE AFFECTED IF YOU DO NOT FOLLOW THESE INSTRUCTIONS.
1 TO OPEN THE STROLLER
A Release storage clip.
B Open out the stroller.
C Using foot, push the brake pedal down fully to engage the primary lock.
WARNING: Ensure that all locking devices are engaged before use.
2 TO OPERATE BRAKES
Locate the brake lever at the back of the buggy frame.
A TO ENGAGE BRAKES: With foot, press down on the left side of the pedal.
B TO RELEASE BRAKES: With foot, press down on the right side of the pedal.
WARNING: Parking device shall be engaged during the loading and unloading
of children.
WARNING: Ensure parking device is engaged before leaving the buggy
unattended.
3 TO OPERATE FRONT WHEEL SWIVEL LOCKS
A TO LOCK SWIVELS: Align front wheels and press down on locking levers.
B TO UNLOCK SWIVELS: Raise locking levers.
4 SEAT BELT/SHOULDER HARNESS OPERATION
WARNING: The seat is not suitable for children under 6 months
WARNING: Avoid serious injury from falling or sliding out. Always use the crotch
strap in combination with the waist and shoulder straps.
TO FIT HARNESS:
A Pull shoulder straps over the childs shoulder then attach to the waist
clips by sliding strap loops onto the hooks.
B Insert both waist clips into the clasp, shoulder straps are secured once
the clips are fastened.
C Adjust strap lengths by sliding buckles. Belt and harness should be snug.
'D' rings are included for an additional harness, if desired.
TO RELEASE HARNESS:
D Press the button on both the front and back of the clasp simultaneously
to release.
5 TO FIT THE SHOPPING BAG
CAUTION: Overloading may cause a hazardous unstable condition to exist.
Maximum load 4.4lb (2kg) evenly distributed. The stroller may be folded with the
bag still attached but all contents must be removed. Failure to do this could
damage stroller and contents of shopping bag.
A Place bag on the 'X' frame under seat with lowest edge of bag at front.
B Attach front straps to front legs just below seat.
C Attach rear straps to rear legs just above horizontal tie bar.
6 TO REMOVE THE CARRY STRAP
A Release the primary lock and secondary lock.
B Press clip release and remove clip from 'D' ring.
C Slide strap loops from handles.
D Using foot, push the brake pedal down fully to engage the primary lock.
7 TO ATTACH THE HOOD
A Slide left hand and right hand pivot blocks DOWN over the retainers
located on the handle tubes.
B Extend hood. Place hood rear flap inside carry strap and attach the
two press studs to corresponding studs on the seat fabric.
C TO ROLL UP THE HOOD Undo poppers, roll up the hood and use Velcro
tabs to secure in place.
8 TO FIT THE RAIN APRON
A Place the apron over hood front.
B Attach the two eyelets (one each side) to the front legs.
C Loop the retaining straps around the rear legs and secure to the
Velcro straps.
9 TO FOLD THE STROLLER
Ensure the hood (if fitted) is folded back. Remove contents of shopping bag.
It is recommended that the harness is fastened before folding the stroller.
A Using foot, lift up on brake pedal to release primary lock.
B Push down on secondary lock lever.
C Grip handles and push forward on stroller.
D Compress folded stroller and engage storage clip.
10 REMOVING AND REFITTING THE SEAT COVER
Remove hood from stroller, if fitted.
A Twist shoulder strap end buckles and feed through holes in the seat
fabric.
B Feed waist strap fasteners through holes in the seat fabric.
C Feed crotch strap buckle through hole in the seat fabric.
D Unfasten seat fabric from handle tubes and seat base tubes.
E Slide fabric from seat base tubes.
Reverse this procedure to refit the seat cover and harness.
3

Publicidad

Tabla de contenido
loading

Tabla de contenido