Kma 802 (Measuring Device); Electrical Connection; 4.4.3 Overflow Temperature - Bosch KMA 802 Manual Origina

4.3

KMA 802 (measuring device)

8
Fig. 10: Measuring device
1. Attach the plate (fig. 10, item 7) to the swivel arm,
ensuring that the guide pipe (fig. 10, item 6) is
pointing outwards (pointing away from the clamping
bed).
2. Remove the cover (fig. 10, item 2) from the electro-
nics compartment.
3. Insert the gas spring (fig. 10, item 1), with the eye
pointing upwards, into the guide tube (fig. 10,
item 3) and position the complete measuring device
from above. Push the guide tube (fig. 10, item 3) on
the measuring device over the guide tube (fig. 10,
item 6) on the swivel arm.
4. Screw the eye of the gas spring (fig. 10, item 1) to the
guide tube (fig. 10, item 3) on the measuring device.
Raise the measuring device until the cross borehole in
the guide tube (fig. 10, item 3) and the eye borehole
in the gas-spring are in alignment and the hexagon-
socket head bolt can be inserted. Screw on the self-
locking nut.
5. Fit cover (fig. 10, item 2) to electronics compart-
ment.
6. Connect the enclosed hoses (fig. 10, item 4, 8) to
the bottom right and left and connect to the two
connections on the swivel arm. Tighten down termi-
nal (fig. 10, item 5).
Robert Bosch GmbH
4.4
4.4.1
1
i
2
1. Connect the keyboard cable to a vacant USB connec-
3
2. Video cable (15-pin connector) to the VGA socket
KMA 800:
1. Insert the PC power cable (230 V) into the X3 plug
4
5
6
2. Insert the monitor power cable (230 V) into the X3
7
3. 9-pin Connect sub-D connector X4 (COM 2) of PC using
458737/8
KMA 822 (trolley):
1. Insert PC power cable (230 V) in socket on the rear
2. Insert the trolley power cable (230 V) into the X3
3. 9-pin Connect sub-D connector X4 (COM 2) of PC
4.4.2
1. Insert connector X1 into 37-pin bush X2 in electrical
2. 9-pin Connect sub-D connector X2 of measuring
4.4.3
¶
Initial Commissioning | KMA 802/822 | 11

Electrical connection

KMA 800/822
The specification and assignment of the PC connec-
tions are described in the PC operating instructions.
tion on the PC.
X9 (video) on the PC.
connector on the EPS electrical cabinet.
plug connector on the EPS electrical cabinet.
the RS 232 connecting cable (3 m) to 9-pin sub-D con-
nector X7 on the EPS electrical cabinet.
panel of the trolley.
plug connector on the EPS electrical cabinet.
using the RS 232 connecting cable (8 m) to 9-pin
sub-D connector X7 on the EPS electrical cabinet.
KMA 802 (measuring device)
cabinet.
device using the RS 232 connecting cable (8 m) to
9-pin sub-D socket X3 (COM1) of the PC
(note designation).
Overflow temperature
Connect temperature sensor to BNC socket X3 on
measuring device.
en
|
1 689 989 349 2017-07-01