Tripp-Lite APS1012SW Manual Del Propietário página 5

1. Overview and Features
1.2.7 Battery Voltage (LED 5-8)
LED 5-8 indicate the battery capacity as detailed in the following table:
Battery Voltage
25%
50%
75%
100%
1.2.8 Voltage Setting (Switch 1-3)*
Switch
DC-to-AC Transfer Delay (Switch 1)
Low Battery Alarm (Switch 2)
AC Transfer Voltage (Switch 3)
*Note:
1. Switch 1 is located farthest from the battery temperature port. See diagram on page 3.
2. All switches must be set before the system is turned on.
3. Switch 2 sets the low battery voltage alarm level (at higher voltage, the alarm sounds sooner).
4. Switch 3: Low-level AC-to-DC voltage point. If the AC input voltage decreases to below the setpoint, the inverter will
automatically switch to DC MODE. Please see the table for details.
Nominal Voltage
On
120V
Off
1.2.9 Search Mode Setting (Switch 4)
Search Mode activates when the unit is operating in inverter mode (battery power) to prevent unnecessary battery discharge
when electrical power is not required. If the inverter is supporting loads that must constantly be powered, turn off switch 4 to
disable Search Mode.
Switch 4
ON
OFF (Default)
1.2.10 Battery Type/Floating Voltage (Switch 5)
Switch 5
ON (Default)
OFF
Note: The unit will charge the battery to Acceptance voltage, continue for up to 12 hours, then drop to Floating voltage.
LED 5
On
On
On
On
Low Voltage Transfer Point (AC-to-DC)
95
85
Floating Voltage
13.8V
13.2V
LED 6
—
On
On
On
ON
30 sec (Default)
11.2V
95V
Search Mode
Enable
Disable
Acceptance Voltage
14.5V
13.8V
5
LED 7
—
—
On
On
OFF
5 sec
10.9V (Default)
85V (Default)
Return Voltage Point (DC-to-AC)
100
90
Function
Inverter only turns on if load > 100W
Inverter is always on in the absence of
AC power
Battery Type
Absorbed Glass Mat (AGM)
Wet-Cell
LED 8
—
—
—
On