Snooze Function - BALDR B0360WST2H2PR-V1 Manual De Usuario

2. When in alarm display mode, press the "ALARM"button to turn on/off
the alarm by the ON/OFF of symbol If on operation for 20 seconds, it
will automatically return to current time display.

SNOOZE FUNCTION

1. When the alarm is ringing, press any other button except top button
to stop the alarm. And the alarm will restart next day.
2. OR when alarm is ringing, press "
function. And the alarm will repeat in 5 minutes. The "
be flashing on screen to indicate the snooze mode. Press any other
button except top button to exit the snooze mode. And the alarm will
restart next day.
3. When alarm rings, the ascending "Bibi"alarm sound will last for 2
minutes if no operation.
PLACEMENT INSTRUCTION
BALDR sensors are sensitive to surrounding environmental conditions.
Proper placement of both the main unit and outdoor sensor are critical
to the accuracy and performance of this product.
Main Unit Placement
Place main unit in a dry area free of dirt and dust. To help ensure an
accurate indoor temperature measurement, be sure to place the Main
unit away from heat sources or vents.
Outdoor Sensor Placement
Sensor must be placed outside to observe outdoor conditions. Sensor
must be placed outside to observe outdoor conditions. Sensor is water
resistant for water splashes and is designed for general outdoor use,
however, to extend its life place the sensor in an area protected from
direct weather elements. The best location is 4 to 8 feet(1.2 to 2.4
meters) above the ground with permanent shade and plenty of fresh
air to circulate around the sensor.When placed by hanging hole ,the
best distance from the wall is more than 1cm for better ventilation.
" button to activate snooze
15
"symbol will