Preparing To Start The Pump - Water Ace R100U Manual Del Usuario

Hazardous pressure. Do not shut off the hose
or the sprinklers while the pump is running. The hose or
sprinkler head may explode.
Connect the Pump Inlet
to the Water Faucet
for use with Sprinklers.
Figure 3: Connect pump to a spigot for use with sprin-
klers. Connect with adapters supplied with pump.
PIPING
Both the suction and discharge ports are tapped for 1" BSP
threads. If using hoses, use hose adapters. See Figure 2. Do
not use a hose on the suction if pumping from lakes, streams
or ponds. The hose will collapse and cause pump failure.
Install a strainer with a foot valve on the end of the suction
line. Inspect and clean the strainer frequently (Figure 4).
115V, GFCI
Protected,
Grounded
Outlet Box
Figure 4: Strainer and foot valve installation.
WA-253P7560
Water Faucet
Hose
Adapters
3942 0401
Discharge Line
(Garden Hose or
Rigid Pipe)
Hose
Adapters
Suction Line
(Garden Hose or
Rigid Pipe)
Foot valve with
strainer (clean
frequently)
NOTICE: An air leak in the suction pipe may draw air in
although no water leaks out. Make sure there are no air leaks
or air pockets in the suction pipe.
PRIMING/OPERATION
NOTICE: Do not run the pump dry. Running the pump without
water can damage the impeller and may damage the seal,
causing leaking or flooding, and will void
warranty.
All suction connections must be airtight. Make sure the suc-
tion lift is not more than 25 feet (7.6M). Fill the pump body
through the priming port before starting the pump. Start the
pump; it should pump water in under 10 minutes (depending
on the length of the suction hose and the height of the pump
above water).

PREPARING TO START THE PUMP

(REFER TO FIGURE 5)
Risk of burns. Never run pump dry. Running
the pump without water may cause the pump to overheat,
damaging the seal and possibly causing burns to persons han-
dling the pump. Fill the pump with water before starting.
Hazardous Pressure. Never run the pump
against closed discharge. To do so can boil water inside pump,
causing hazardous pressure in unit, risk of explosion and pos-
sibly scalding persons handling pump.
1. Remove the priming plug from the priming tee and fill the
pump. Fill all piping between the pump and the well and
make sure that all piping in the well is full. If you have
also installed a priming tee in the suction piping, remove
the plug from the tee and fill the suction piping. See
Figure 5.
Figure 5: Prime the Pump.
4
Remove the
plug and
fill the pump
and the piping
through the
priming tee.