1. Mark centerline appearance panel: Mark centerline of
appearance with marker or tape.
3. Lower exhaust: Lower the exhaust by detaching it from the rubber isolator.
Spraying a lubricant or soapy water on the metal hanger rod and the rubber
isolator helps removal
©2016 Cequent™ Performance Products, Inc. -
2. Remove appearance panel: Remove 5 Philips screw, 9 plastic rivet (Rivets are released by first
pulling out center post of rivet, then remove remaining post), 4 plastic screws with large screwdriver
(pull on panel for ease of removal).
Printed in Mexico
4. Remove plug and tape: Remove the rubber plugs (1 each side) and if present
remove tape covering the weld nuts (3 each side). Run bolts from fastener kit into
weld nuts to confirm no interference.
Sheet 4 of 18
76112NP
11-10-16
Rev. B