Publicidad
Idiomas disponibles
Idiomas disponibles
Always wear SAFETY GLASSES
when installing hitch
2"
[50.8mm]
Figure A
2013-2015
Fascia trimming required
©2017 Cequent™ Performance Products, Inc. -
Installation Instructions
PART NUMBERS: 76134, 84134, CQT76134
Fascia trimming required -
Note: Obtain owners permission before installing
Appearance panel trimming
or removal required
1" [25.4
Figure 1
2016- Current
Fascia trimming required
See Step 12.
* Optional
Passenger's side – trim
1-1/4" [31.75mm]
down on long side
Figure 2
* Optional
Driver's side – trim
along notches on
the "
underside
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or
other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced.
Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
Figure 3
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York,
V.E.S.C. Regulation V-5 and SAE J684.
Printed in Mexico
Rear
Lift gate sensor reduced to this area on vehicles with
HANDS-FREE, FOOT-ACTIVATED POWER LIFTGATE" option.
Sheet 3 of 12
Fastener Kit : 76134F
①
Qty.(5)
Bolt
M12x1.25x40 CL10.9
②
Qty. (5)
Conical washer
1/2 ''
③
Qty. (2)
Cable ties
Existing
weld nut
Frame rail
Crosstube
③
76134N
2-3-17
(Conical Washer)
Teeth side
against hitch
②
①
Scan for step by step
PHOTO installation
instruction or visit
http://www.cequentgro
up.com/qr-product.aspx
Rev. A
Publicidad
