Cequent Performance Products 24953 Instrucciones De Instalación página 4

1a. Remove Fascia and Taillights - Using a 10mm socket, remove (6) screws from bottom of fascia.
1b. Using a flat screw driver, remove (5) plastic push rivets from each
1c. Using an 8mm socket, remove (1) screw located vertically in the
wheel well by prying the center pin out of each rivet. Using a fork
upper area behind the wheel well liner, (1) per side.
shaped trim panel tool under head of each rivet, gently remove the
rivets. NOTE: Two (2) of the rivets are behind the wheel well liner.
©2016 Cequent™ Performance Products, Inc. - Sheet 4 of 24 24953NP 10-12-16 Rev. A
Printed in Mexico