Cequent Performance Products 24947 Instrucciones De Instalación página 5

2. Remove taillights - Open trunk. Using a T15 torx bit, remove (2)
screws from taillight housing and a Philips head screw driver to
remove (1) screw from taillight housing, both sides. Gently pull the
taillights rearward. Disconnect the wiring from taillights.
3b. Remove fascia - Disconnect the wiring from fascia if equipped.
©2016 Cequent™ Performance Products, Inc. -
Printed in Mexico
3a. Remove fascia - using a plastic trim panel tool, gently remove the
plastic fascia starting at the outer edges near the wheel wells
4. Remove exhaust hanger - using a 13mm socket, remove the (2)
bolts from the exhaust hanger. Unhook the exhaust hanger from the
hooks on end panel. NOTE: Support the exhaust before unhooking
the exhaust hanger.
Sheet 5 of 21 24947NP 9-19-16 Rev. B