Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Listening to the demo songs
Listening to the demo songs
Loading the demo song data
When you perform the following operation, the
data stored within the KROME will be discarded
and overwritten by the preset program and
combination data and the demo song data. If you
don't want to lose the data that you edited or
created, you should save it to an SD card
(commercially available) before you proceed.
1. Press the GLOBAL button (the LED will light up)
to enter Global mode.
2. Access the Global P0: Basic Setup page.
If another page is displayed, press the EXIT button.
3. Press the menu button on the upper right side of
the display, and choose "Load Preload/Demo
Data."
4. In the "Kind" field, choose "All (Preload PCG and
Demo Songs)."
When you execute loading, the preloaded data and the
demo song data will be loaded.
5. Press the OK button or ENTER button.
A dialog box will ask you for confirmation.
Press the OK button or ENTER button once again to
load the data.
Never turn off the power while data is being
loaded.
If the Memory Protected dialog appears, press the
System Pref. tab and clear the check mark from the
Memory Protect Song setting. Then load the data
again.
22
En-
Listening to the demo songs
Here's how to listen to the demo songs in Sequencer
mode.
1. Press the SEQ button (the LED will light up) to
enter Sequencer mode.
2. Access the P0: Play/REC– Program T01–08 page.
If this page is not displayed, you'll need to press the
EXIT button a few times.
Song Select
Popup
Track Select
Category
Program
Select,
& Popup
Play/Mute/Rec
Solo
Track 1
Track 2
3. Let's start by listening to song S000.
Verify that song S000 is selected. If another song is
selected, press the song name display area (Song
Select) to highlight it. Then press the numeric key 0,
and then the ENTER button.
4. Press the SEQUENCER START/STOP (
button.
The LED will blink, and the song will begin playing
back.
5. If you want to stop playback mid-way through the
song, press the START/STOP (
again.
6. Let's listen to the next song.
Press the song name display area (Song Select). Press
the numeric key 1, and then press the ENTER button.
(Song "S001" will be selected.)
Alternatively, you can press the round button (Song
Select popup) located to the left of the song name, and
a list of song names will appear. Press one of the song
names to select a song.
7. Press the START/STOP (
playback. To stop playback, press the
START/STOP (
) button once again.
The demo song will not be retained when the
power is turned off, but you can load it again at
any time.
Meter
Tempo
)
) button once
) button to begin
Publicidad
Capítulos
Tabla de contenido
