Audio Outputs; Connecting The Keyboard And Turning; Turning The Power On - Korg Krome EX Guia De Inicio Rapido

Connecting the keyboard and turning the power on

AUDIO OUTPUTS

4. AUDIO OUTPUT L/MONO, R jack
These are the main stereo audio outputs. Use the
VOLUME knob to adjust the volume.
PEDALS
5. ASSIGNABLE PEDAL jack, ASSIGNABLE
SWITCH jack, DAMPER jack
You can connect a damper pedal, foot switch, and foot
pedal to these jacks. This gives you a broader range of
functions and effects to control.
MIDI
6. MIDI IN connector, MIDI OUT connector
MIDI lets you connect the KROME to a computer or
other MIDI devices, for sending and receiving notes,
controller gestures, sound settings, and so on.
Connecting the keyboard and turning the power on

Turning the power on

Note: Check the following before you turn the power
on.
• Make sure that you're using an AC outlet that
supplies the correct voltage for your unit.
• Use only the included AC adapter.
• Turn the KROME's front panel VOLUME knob all
the way to the left to minimize the volume.
• Make sure that the KROME's power is off.
• If you're connecting to an external output device
such as a mixer or a powered monitor speaker,
minimize its volume and turn off its power.
Here's how to connect the power.
1. Connect the included AC adapter's DC plug to the
AC adapter connector located on the KROME's
rear panel.
Plug the power cord into an AC outlet.
Connect the power cord to the AC adapter.
To prevent the DC plug from being disconnected
accidentally, fasten the cable around the KROME's
cable hook.
8
En-
SD
7. SD card slot
You can insert an SD card here, and use it to save/load
KROME programs, combinations, or song data. (See
page 20)
USB
8. USB connector (for connecting to
computer)
You can connect your computer to this connector.
Using a single USB cable, your KROME can send and
receive MIDI information directly to and from a
computer, without requiring a MIDI interface.
Note: The USB connector of the KROME is only able to
transmit and receive MIDI data.
AC adapter connections
a: AC adapter
connector
Power switch
When fastening the
cable to the cable
hook, take care not
to bend this portion
any more than
necessary.
2. Connect the KROME's AUDIO OUTPUT
L/MONO and R jacks to your mixer or powered
monitor speakers.
• If you're monitoring through headphones, connect
them to the headphone jack that's located on the
left side of the front of the KROME. This
headphone jack will output the same signal as the
stereo output (AUDIO OUTPUT L/MONO and R).
3. Turn on the power by pressing the power switch
located on the rear panel of the KROME.
If the auto power-off function is enabled, a
message will appear at start-up, informing you of
the time until the power will turn off
automatically. If this dialog box does not appear,
auto power-off is not enabled; the power will not
turn off automatically. (See "The auto power-off
function" on page 9.)
4. Power-on your external output devices, and adjust
their volume appropriately.
5. While playing the keyboard, gradually turn the
VOLUME knob toward the right to adjust the
volume.
d: Cable hook
AC adapter
b: Power cord for AC
adapter
c: Plug into AC outlet.