Technical Specifications; Preparation For First Use - Holmatro AHS 1400 FDU Manual

3.4

Technical specifications

/i
Item
Application
Allowable pressure
Power source
Maximum air pressure
Hydraulic oil capacity (effective)
Delivery, unloaded
Delivery, loaded
Air consumption, unloaded
Air consumption, loaded
Air connection
Hydraulic connections
Type of hydraulic oil
Noise level
Vibration level
Temperature range
Standards
Directives
Country of manufacture
3.5 Accessories
/i
Description
Oil lubricator.
Air filter with water separator.
4

Preparation for first use

4.1 General
• Check the equipment for completeness and damage. Do not use the equipment if it is damaged; in
that case contact the Holmatro dealer.
• Check that the correct pressure relief tool is present for the coupler system in use: the CORE™
system or the dual or single hose system.
• Make sure the pump is in a horizontal position.
4.2 Initial use
When you receive the pump it must first be prepared for operation.
• Check whether all hose connections are firmly tightened.
• Check that the pump is supplied with hydraulic oil in the tank.
• Remove the transport plug from the hydraulic oil tank. Fit the supplied hydraulic oil filling/vent cap
(Fig. 2/5). See also the label on the pump.
AHS
Unit
bar
bar
3
cm (cc)
3
cm /min (cc/min)
3
cm /min (cc/min)
l/min
l/min
dB(A)
2
m/s
°C
916.219.125_005
AHS 1400 FDU (C)
Rescue tools, controls on the tool
720
air powered
8
1400
960
410
700
580
1/4" BSP
CORE™ or Dual-hose
ISO-L HV VG 15
< 81
< 2.5
-20 to +55
EN 13204 / NFPA 1936
2006/42/EC
The Netherlands
Part number
510.511.105
510.502.033
EN
27