Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6.2. WHASING SPRAY JET SYSTEM
19. Rejilla para depósitos de pistolas
20. Boquilla pulverizadora
21. Pulverizador de limpieza
22. Boquilla de soplado
23. Soporte para tapas de depósitos
24. Tuerca fijación de la araña
25. Clip de pistolas en Nylon
6.3. MAIN MACHINE CONTROLS
26. Automatic washing timer
27. Valve ON/OFF main machine
28. Valve ON/OFF of the atomized
29. Valve ON/OFF brush
30. Rinse button
31. Exchange valve dirt-clean
32. Labels for warnings
INCORRECT INSTALLATION OF THE MACHINE
MAY CAUSE DAMAGE TO PEOPLE, ANIMALS OR
OBJECTS. THE MANUFACTURER CANNOT BE
CONSIDERED
RESPONSIBLE
DAMAGES.
7.1 TRANSPORT AND DISCHARGE
The equipment COMPACT 235 is delivered packa-
ged. It must be transported and stored according to
the indications on the packaging.
Due to the low weight of the equipment COMPACT
235 can be moved by two people without using other
means.
7.2 ARRANGEMENT OF THE LIGHTING SYSTEM
The Client must make sure that there is suitable
lighting for the surroundings and that the lighting
conforms to the regulations in force. In particular, the
Client must arrange the positioning of lighting that
illuminates all the working area.
7.3 ARRANGEMENT OF THE PNEUMATIC
SYSTEM
The Client must arrange a line of filtered compressed
air supplied by a compressor that is suitable for the
consumption required. Do not use compressed air
25
7. INSTALATION
that contains chemical products, synthetic oil with
organic solvents, salts or corrosive gases as they
can cause damage or malfunctioning. The minimum
FOR
THESE
level of filtering should be 40 microns. The line of
compressed air must arrive up to the supply points of
the machine. If the compressed air contains a large
amount of moisture, it may cause malfunctioning in
the valves and in the pneumatic components. Install
a moisture separator downstream from the compres-
sor to avoid this.
7.4. CLASSIFICATION ACCORDING TO THE ATEX
DIRECTIVE
The machine conforms to the essential requisites of
the EU Directive 2014/34/UE, better known as ATEX
("Explosive atmospheres"). It is classified as group II
category 3 letter G system. The assessment proce-
dures of conformity, carried out by an internal factory
check, allow the installation of the machine in
surroundings where there may be potentially explosi-
ve atmospheres due to the presence of gas, fumes
or mist.
Preparation for extraction of gases.
For the compliance ATEX, the machine is equipped
with a system of forced evacuation of the fumes
generated during the operation.
- 18 -
21
20
19
22
23
26
27
31
30
24
28
29
32
Publicidad
Capítulos
Tabla de contenido
