Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Close the lid of the tub. Turn the On/Off switch
(No.27) on the machine to ON. Turn the dirty-clean
(No.31) lever to vertical position for recirculation.
Set the washing timer (No.26) by turning it clockwise
to the desired time. The solvent aspirated from the
recirculation solvent tank will begin to come out of
the dispenser nozzles (No.20) and the spray gun
nozzle (No.21) of the spray jet nozzle system inside
the tub to perform further washing of the parts, while
the blower nozzles (No.22) will deliver air.
If the lid of the tub is opened during the wash cycle,
the pump stops, stopping the wash cycle. In any
case it is strictly forbidden to open the lid of the tub
during washing to prevent any spurts of detergent
coming out of the tub on account of the residual pres-
sure inside the tubes.
Once the wash time set has elapsed the pump stops
and the vapour suction begins.
8.2. FINAL AUTOMATIC RINSE
Position the dirty-clean lever (No.31) in the rinse
position (horizontal) for clean solvent and press the
rinse button (No.30) for the desired time for this
operation. This way the dispenser nozzles of the
washing spray jet system will spray clean solvent into
the tub and the blower nozzles will deliver air.
Rinsing of the pieces in the tub terminates when the
rinse button is released and aspiration works.
ATTENTION: Press the rinse button only for the few
seconds needed for this operation to avoid wasting
clean solvent.
The clean solvent used to rinse the pieces is drained
off into the drum of already used solvent.
Open the lid of the tub and remove the parts of the
gun from the various supports. When performing
these operations, the air suction will work.
Blow some air on the spare parts to dry them by
means of the air blow gun, if necessary.
Once the washing operations have been completed,
close the lid of the tub level and the lid of the machine.
Always check the position of the dirty-clean lever
(No.31), before performing the initial wash of the
spray guns: it must be vertical for recirculation
solvent, so as not to waste clean solvent.
If you want to blow air on the gun parts to dry, use the
special dispenser air gun (No.18).
After finishing the washing operation close the lid of
the tank and switch OFF general ON / OFF valve to
stop the intake of the fumes.
8.3. MANUAL CLEANING WITH BRUSH
Put the ON/OFF switch (No.29) in the ON position to
dispense recycled solvent trough the brush.
8.4. MANUAL RINSING WITH ATOMIZED USE OF
SOLVENT
On the suction hood, a nozzle is present for nebuli-
zed from which protrudes a small amount of clean
solvent in spray form.
Turn ON the ON/OFF valve general (No.27), turn On
the valve ON/OFF of the atomized if you want a
manual rinsing of the pieces or to take clean solvent.
Keep the lid of the tank opened not to disperse the
solvent.
The solvent used to clean the spray will fall within the
dirty solvent drum through the discharge place on the
washing tub.
- 20 -
Publicidad
Capítulos
Tabla de contenido
