Publicidad
Step 10
1
D494
F
Groove
Insert the DRAWER SIDES (D494 and D495) at an angle
å
into the slot at each end of the DRAWER FRONT (F).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Fasten the DRAWER BACK (D78) to the DRAWER SIDES (D494 and D495). Use four BLACK 1-9/16" FLAT HEAD
å
SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D708) inserts into the groove of the DRAWER BACK (D78).
å
Repeat this step for the small drawers using the SMALL DRAWER FRONTS (K), SMALL DRAWER BACKS (D109), SMALL
å
DRAWER SIDES (D496 and D497), and SMALL DRAWER BOTTOMS (D707).
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D495
D78
D494
D708
VIEW THE T-LOCK BOX VIDEO
2
U n
s u
D494
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D708) into the grooves in the
å
DRAWER SIDES (D494 and D495) and DRAWER FRONT (F).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D495
419612
With the palm of your
hand, tap the DRAWER
BOTTOM down into
the groove.
fi n
i s h
r f a
e d
c e
D708
D495
F
30S
(12 used in this step)
Page 15
Publicidad
