Publicidad
Step 2
Step
Separate the EXTENSION SLIDES (M) from the EXTENSION RAILS (L) as shown in the enlarged diagram below. Be
å
prepared, the parts are greasy.
Fasten two EXTENSION RAILS (L) to the ENDS (A and B). Use four GOLD 5/16" FLAT HEAD SCREWS (3S) through holes
å
#1 and #4.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner cartridge
å
of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
Using your hammer, gently tap four SUPPORT PINS (4R) into the holes in the ENDS (A and B).
å
NOTE: Be sure to use the exact holes shown in the ENDS.
å
Open end
www.sauder.com/services
M
Push the black lever in and pull the SLIDE from the RAIL.
B
3
2
L
1
This hole
must be here.
A
4
4
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
419612
L
1
L
2
3
4R
3S
Open end
This hole
must be here.
Page 7
Publicidad
