Klarstein 10030977 Manual Del Usario página 14

OSC Key
After the fan starts, repeatedly touch this button to start or stop oscillation.
PRO Key (Timer)
Under power-on state, timed power-off can be set. Press the PRO button; it starts the timing
power-off state. „Timing" and icon displayed on the fan display will flash once per second.
• Rotate the driving plate clockwise, the fan display will change: 0.5 > 1.0 > ... > 12.0 > 00.
• Rotate the driving plate anti-clockwise, the fan display will change: 7.5 > ... > 0.5 > 00 > 12.0 > ...
When set a time, 5 seconds without any operation, the timing on the display flashes twice and
beep to refer successfully settings, if there is any button operation in five seconds (except for on/
off button), the time is successfully set and the fan returns to current state immediately, „Timing"
and icon stops flashing, if the timing button is pressed in five seconds then timing is cancelled.
If there is time setting, then "Timing" and icon is lit, if not, it is off. When setup is successful, the
display returns to display the wind level.
Under standby mode, press the PRO button to set power-on time, „PRO" and icon is lit, the ope-
ration mode please refers to timed power-off; rotate the drive plate to adjust the time. After ad-
justment, the set time will be displayed on the screen. To cancel a time setting, user only need to
repeatedly press the PRO button.
Note: Under working state, press forward/timing button to enter the timing status, user can check
the set time, and user can re-set the time in five seconds; if no operation within five seconds, the
time shown on the screen flashes twice and returned to the wind level.
Control Panel and Functions
On/Off:
Same as them on remote control.
Function button:
Under working state, short press the function button, the fan will alternate
between oscillation and fix; Long press the button, the fan enters into the
timing function, refer to the operating instructions of PRO button on re-
mote control (To cancel the timer, long press function button).
Under standby mode, short press of the function button is invalid; Long
press the function button, the fan enters into the appointment starting
function, refer to the operating instructions of PRO button on remote con-
trol (To cancel the timer, long press function button).
14