Operation Only By Remote Control - Klarstein Hot Spot Pebble Manual Del Usuario

OPERATION ONLY BY REMOTE CONTROL

Note: During the operation of the remote control ,remote control transmitter must aim
at remote control receiving area of product, avoid remote control ineffective.
Operation
1. Press the POWER button
A in the picture below).
2. Press button for one time. The appliance works with low heating and display
shows "--" and " " (see display B in the picture below).
3. Press button . the appliance works with low heating and display shows "--" and
" " (see display C in the picture below).
Setting the Timer
The TIMER button on the remote control operates as same as the TIMER button on
the control panel of the appliance.
Set current TIME/DAY
The settings can be made both under standby mode and working status.
1. Press the SET button
button or to set current hour (total in 24 hours).
2. Press the SET button
or to set current minute (00-59 minutes).
3. Then press the SET button
the button or to set current day (Monday-Sunday: d1-d7)
4. Then press the OK button
settings.
. The appliance enters into working status (see display
for one time. The display shows "12" as default. Press the
again. The display shows minute "30". Press the button
for third time, the display shows the day "
to confirm the setting, the display will show previous
"Press
EN
25