Klarstein Hot Spot Pebble Manual Del Usuario página 28

EN
28
Set open-window detection
1. Press the POWER button
a moment until stable.
2. Press the button on remote control. The light "
temperature display "23" by default. Press the button
temperature.
During open-window detection mode, once the ambient temperature drops
5-10 °C within 10 minutes, then the product will stop working within 30 minutes
and will enter into standby mode. Then press the POWER button
appliance.
3. Press the button again to turn off the open-window detection. The light "
go off and the appliance will resume to previous working mode.
For example: The display F in the picture below shows the following settings:
23 °C (target temperature) during open window detection.
4. When turn on at the same time for both open-window detection and weekly
program, during the OFF period of weekly program, the product doesn't work.
During the working status of weekly program, the temperature is subject to the
setting temperature of open-window detection (see display G on the picture below).
Note: When the weekly timer function is enabled, you must set the weekly timer and
the working week and time period, otherwise, the default state of the weekly timer is
"00", that is, the power-off state.
. the appliance enters into working status. Heating for
" and "°C" will be on. The
or to set target
to turn on the
" will