ENGLISH
or pillows fitted with foam rubber pads should not be dried
in the washer dryer.
Fabric softeners, or similar products, should only be used as
•
specified by the product manufacturer's instructions.
Remove all objects from items that could be a source of fire
•
ignition such as lighters or matches.
Never stop the washer dryer before the end of the drying
•
cycle unless all items are quickly removed and separated so
that residual heat can dissipate.
The final part of the washer dryer cycle takes place without
•
heat (cool down cycle) to ensure that items reach a
temperature that will not cause damage to them.
Do not use high pressure water sprays and/or steam to
•
clean the appliance.
Clean the appliance with a moist cloth. Use only neutral
•
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects.
Before any maintenance operation, deactivate the appliance
•
and disconnect the mains plug from the socket.
Safety instructions
Installation
The installation must comply with
relevant national regulations.
• Follow the installation instructions
supplied with the appliance.
• Do not use the appliance before installing
it in the built-in structure due to safety
manner.
• Do not install or use the appliance where
the temperature can be less than 0°C or
where it is exposed to the weather.
• Always keep the appliance vertical when it
is being moved.
• Make sure that there is air circulation
between the appliance and the floor.
• Remove all the packaging and the transit
bolts.
• The floor area on which the appliance is
to be installed must be flat, stable, heat
resistant and clean.
• Keep the transit bolts in a safe place. If
the appliance is to be moved in the future
they must be reattached to lock the drum
to prevent an internal damage.
• Always take care when moving the
appliance as it is heavy. Always use safety
gloves and enclosed footwear.
• Do not install or use a damaged
appliance.
• Do not install the appliance where the
appliance door cannot be fully opened.
• Adjust the feet to have the necessary
space between the appliance and the
flooring.
8