Installation Instructions - Cequent Performance Products 60298 Instrucciones De Instalación

Exhaust Hangers
Remove this muffler
hanger peg out of rubber
isolator on forward side
of muffler, Driver's side.
Picture 2.
Remove similar hanger peg
on Passenger's side of
vehicle also.
Passenger side vehicle frame rail
(Showing attachment holes)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
© 2012 Cequent Performance Products

Installation Instructions

Chevrolet Orlando
Remove this bolt to drop rear
hanger on Driver's side.
Large diameter
fish-wire hole.
(
Mirror image on
Driver's side)
Picture 5.
These are the (2)
attachment holes to
fish-wire bolts to.
Tighten 7/16"-Gr.5 Carriage Bolts with torque wrench to 50 Lb.-Ft. (68 N*M),
All models
Picture 3.
Exhaust shown resting on
rear axle after removing
all (3) hangers.
Trim heat shield as shown by cutting out hatched section. You can
either remove a small section to this line or cut out the whole larger
Heat Shield Trim
Picture 4.
This portion of shield is
sandwiched between hitch
and vehicle frame.
Sheet 2 of 6 60298N
Part Numbers:
Picture 1.
section to the edge.
2-7-12
60298
24881
77268
Rev. B