Publicidad
Idiomas disponibles
Idiomas disponibles
Frame rail
Rearward
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75808SAF
Wrenches: 19 mm, 22 mm, 3/4"
Note: Fasteners
typical both sides
j
Qty. (2)
Hex Bolt M12 x 1.50 mm x 45 mm CL 10.9
k
Conical Washer 1/2"
Qty. (2)
l
Qty. (2)
Hex Bolt M14 x 2.00 mm x 120 mm CL 8.8
m
Qty. (2)
Hex Nut M14 x 2.00 mm CL 8.8
1.
CAUTION: SUPPORT THE BUMPER STRUCTURE AS REQUIRED DURING HITCH INSTALLATION.
2.
Remove the factory-installed bumper bracket (one side at a time).
3.
Loosely attach the side bracket and bumper bracket (removed in Step 2) to the inboard side of the frame rail as shown.
4.
Repeat Steps 2-3 for the other side of the vehicle.
5.
Placing the receiver assembly between the side brackets, install the remaining fasteners as shown.
6.
Torque all fasteners to specification.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
© 2013 Cequent Performance Products, Inc.
Printed in Mexico
Installation Instructions
Volkswagen Amarok
Fascia
Receiver Assembly
(Install As Shown)
q
Side Bracket
Both Sides
Tighten all M12 CL 10.9 fasteners with torque wrench to 92 Lb.-Ft. (125 N*M)
Tighten all M14 CL 8.8 fasteners with torque wrench to 100 Lb.-Ft. (136 N*M)
Tighten all 1/2"-20 GR. 5 fasteners with torque wrench to 90 Lb.-Ft. (122 N*M)
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: PU3
k
j
n
m
o
Frame Bushing
p
n
Conical Washer 5/8"
Qty. (2)
o
Hex Bolt 1/2"-20 x 1-1/2" GR. 5
Qty. (6)
p
Hardened Flat Washer 1/2"
Qty. (6)
q
Flanged Lock Nut 1/2"-20 GR. G
Qty. (6)
Sheet 3 of 3
75808SAN
Part Numbers:
75808SA
Max Gross
Trailer WT (LB)
8,000 (3632 Kg)
800 (363 Kg)
4,000 (1816 Kg)
600 (272 Kg)
Accessory Rating
Existing M12
Factory-Installed
Bumper Bracket
Both Sides
Both Sides
Frame Rail
Both Sides
l
Both Sides
11-26-13
Form: F205 Rev C 9-17-2012
Max Tongue
WT (LB)
C
Weld Nut
REV. A
Publicidad
