Publicidad
Idiomas disponibles
Idiomas disponibles
Looking down on surface that is against vehicle underbody when installed.
Cut Heat Shield in half at this line.
Remove (3) nuts holding heat shield to underbody using 10mm socket or
wrench. After trimming reinstall shield in place using the (2) remaining holes.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
© 2010, 2011, 2015 Cequent Performance Products - Printed in Mexico
Installation Instructions
Ford Fiesta 5-Door Hatchback All
Details for muffler heat shield trimming.
Do this step before installing hitch. When heat shield has been
trimmed and reinstalled then proceed to Step 2 on previous page.
Top View of Heat Shield.
Vehicle Forward
Models
1"
Sheet 2 of 6
24855N
Part Numbers:
24855
60271
77228
24847 U-Haul
10-07-15
Rev. D
Form: F205 Rev A 5-6-05
Publicidad
