EAS ELECTRIC ETW8120W Manual De Usuario página 34

Clean Inlet valve filter
The inlet filter shall be cleaned if there is not any or insufficient water in
when the tap is opened.
1.Lower the water pressure:
a.Close the tap.
b.Select any procedure except "Spin" procedure.
c.Press the button "Start/Pause" and keep
the procedure running for about 40 seconds.
d.Pull out the power plug.
2.Remove the inlet hose from the tap.
3.Use water to wash the filter.
4.Reconnect the inlet hose.
Clean detergent drawer
1.Press down the part
① inside the drawer and take
out the detergent drawer.
2.Lift the clip up and take out
softener cover and wash all
grooves with water.
3.Restore the softener cover and
push the drawer into positon.
Dispose an easily get frozen washer
If the washer is exposed to temperature below 0°C, certain precaution
should be taken.
1.turn off the tap.
2.Unscrew the inlet hose.
3.Unhook the drain hose from the rear support and position the end of
this hose and that of the inlet hose in a bowl.Run the spin programme.
4.Disconnect the washer.
5.Screw the inlet hose and reposition the drain hose.
1.When the washing machine is reused, make sure the ambient
temperature is above 0°C.
2.If your washing machine is located in the room where it can get frozen
easily, please drain the remaining water inside drain hose and inlet
hose thoroughly.
3.Please contact a technician if your washer is frozen.
V.3
34