How To Open Looper Cover; Principal Parts Behind Looper Cover; Preparation Prior To Sewing - Singer HD0400S Manual De Instrucciones

6. HOW TO OPEN LOOPER COVER

Caution:
Be sure to turn off power switch.
Push the cover to the right as far as it will go 1 .
Pull cover down toward you 2 .
Caution:
Be sure looper cover is closed when sewing.
7. PRINCIPAL PARTS BEHIND
LOOPER COVER
1 Upper looper
2 movable upper knife
3 Presser foot
4 Stationary lower knife
5 Lower looper
6 Seam width finger knob
7 Seam width adjustment knob

8. PREPARATION PRIOR TO SEWING

Connect the controller / electric plug 1 to the
machine receptacle 2.
Plug power line 3 into electric outlet 4.
Power Switch: Push "-" mark side to turn "ON".
Push "O" mark side to turn "OFF".
To run the machine and control the speed, press
the controller.
The harder you press, the faster the machine will
sew.
To stop the machine from sewing, remove your foot
from the controller.
WARNING:
Use only foot controller provided with this
machine.(YC-482 for U.S.A. & CANADA only)
Be sure to make reference to "Warning" on
following page.
9