How To Wire Your Ceiling Fan - Fanimation CREASE LP8357LMW Manual Del Usuario

To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before hanging
(Figure 1).
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice, as
it must be grounded for safe operation.
CAUTION: INCORRECT WIRE CONNECTION WILL
DAMAGE THIS RECEIVER.
1. Connect wires using connectors as shown in Figure 2.
NOTE: If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan installed
by a licensed electrician.
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors except for the ground wire. Do not
operate fan until the blades are in place. Noise and
motor damage could result.
2. After connections have been made, turn leads
upward and carefully push leads into the outlet
box, with the white and green leads to one side
of the box and the black leads to the other side.
(Figure 3)
3. Once the connection has been made, slide the
receiver into the hanger bracket, taking care not to
pinch the wires. (Figure 4)

How to Wire Your Ceiling Fan

WARNING
WARNING
BLACK(Mains/Live)
BLUE
(Light/Live)
BLACK
(Fan/Live)
WHITE
(Fan/Neutral)
HARDWARE USED:
WIRE
CONNECTORS
Green Wire
from Supply
(Ground)
Green Wire
from Hanger
Bracket (Ground)
Green Wire
from Hanger
Ball (Ground)
10
MAIN FUSE BOX
Figure 1
AC Power Supply
WHITE(Mains/Neutral)
Figure 2
x 3
White Wire
from Supply
Listed
Outlet Box
Household
White Wire Supply
from Fan
Black Wire
from Supply
Black Wire
from Fan
Figure 3
Figure 4
Antenna
BLACK