Programming A Spin Step; Programming A Rinse Step - Alliance Laundry Systems UW35P2 Manual De Operación

Programming
Step Programming

Programming a Spin Step

1. The computer must be in the PROGRAM
mode, and the cycle programming
sequence must be ready for the next step.
2. Press the Medium Speed or High Speed
key. The display will read "MSnncc"
for medium speed or "HS" for high
speed spin.
Note: The WE-6 microcomputer inserts an
automatic 30-second medium-speed spin
before going to high speed for the programmed
time.
3. Press the Enter key. The display will read
"M---S." Now assign time in minutes and
seconds to the spin step.
4. Press the Enter key. The display will read
"SDLY" for one second. The display will
then change to "0M-00S."
5. Now assign the time for the spin delay
(coast down). A minimum of 30 seconds is
recommended to reduce belt wear.
A spin delay is always advisable after a
high speed spin.
Also, always program a spin delay after a
high speed spin if another (non-spin) step
is to follow.
46
(Continued)
Note: Do not program a Wash 1 step for a
shakeout after the spin step. If such a step is
programmed, the computer will revert to the
previous wash step and will fill with water
accordingly. See Stop Routine. However, a
Wash 1, 2, or 3 step programmed for ONE
second will select stop routine agitation, and
avoid refilling.

Programming a Rinse Step

When the Rinse key is pressed on the keypad,
the drain will remain open and the basket
will rotate in medium spin speed. Water is
added through the door spray nozzle only.
To program a rinse step, use the following
procedure:
1. The computer must be in the PROGRAM
mode, and the cycle programming
sequence must be ready for the next step.
2. Press a water temperature key (Cold, Hot,
or Warm). If the Cold key is pressed, for
example, the display will read "C-nncc,"
etc. Then press the Rinse key. The display
will read "CRnncc," "HRnncc," or
"WRnncc," depending on whether cold,
hot, or warm temperature was selected.
3. Press the Enter key. The display will read
"M---S." Now assign the time in minutes
and seconds desired for the duration of the
rinse step.
4. Press the Enter key, and go to the next
step in the cycle.
F232090