The device will automatically configure the IP address of a camera connected by LAN if:
The connected IP camera is our brand's IP camera.
Reset the IP camera to default value (the default IP configuration method of the camera is "DHCP").
The camera is powered on before the device is powered on.
If the device doesn't configure the IP address of your camera automatically as described above, your IP
camera might NOT be:
Our brand's IP camera.
Set to "DHCP" as its default IP configuration method.
To solve this, use our brand's IP camera, and reconfigure its IP address to 10.1.1.xx (xx ranges from 11 ~
253), in the same network segment as the device.
a) Move your mouse to the left side of the screen to show the quick bar, and select "
every connected IP camera with its connection status to this device and MAC address.
b) Select the IP address which is not used, and select "SETUP".
IP
PORT
10.1.1.12
88
10.1.1.12
88
10.1.1.13
88
10.1.1.13
88
10.1.2.14
88
10.1.2.14
88
10.1.1.15
88
10.1.1.15
88
10.1.1.16
88
10.1.1.16
88
10.1.1.17
88
10.1.1.17
88
c) Select "DHCP" in "NETWORK TYPE".
d) Click "APPLY" and "EXIT" to save your changes.
NETWORK TYPE
IP
PORT
USER NAME
PASSWORD
NETMASK
GATEWAY
PRIMARY DNS
e) The device will then detect the IP camera and display images soon.
IP SEARCH
MAC
00:0e:53:e5:9a:f1
IP CAMERA
UNKNOWN
IP CAMERA
00:0e:53:a6:91:18
IP CAMERA
UNKNOWN
IP CAMERA
00:0e:53:a5:9f:a2
00:0e:53:a5:9f:a2
00:0e:53:e1:4e:k5
IP CAMERA
UNKNOWN
IP CAMERA
00:0e:53:s5:3e:h6
IP CAMERA
UNKNOWN
IP CAMERA
00:0e:53:e6:4b:26
IP CAMERA
UNKNOWN
IP CAMERA
SETUP
DHCP
10.1.1.14
88
admin
*****
255.0.0.0
10.1.1.10
168.95.1.1
APPLY
EXIT
5
TYPE
PROTOCOL
AVTECH
ONVIF
AVTECH
ONVIF
SWITCH
AVTECH
SWITCH
AVTECH
AVTECH
ONVIF
AVTECH
ONVIF
AVTECH
ONVIF
CONNECT
SETUP
CONNECTION
". You'll see the list of
STATUS
CONNECTED TO CH1
CONNECTED TO CH1
CONNECTED TO CH2
CONNECTED TO CH2
UNUSED
UNUSED
CONNECTED TO CH3
CONNECTED TO CH3
CONNECTED TO CH4
CONNECTED TO CH4
CONNECTED TO CH5
CONNECTED TO CH5
EXIT