EAS ELECTRIC ECH R32 Serie Manual De Instalación Y Usuario página 73

Tips:The value of "Tw_Heat1_OFF" is bigger
than "Tw_Heat1_ON".
HEAT2 function is disabled, so user can not
enter the HEAT2 interface.
◆
Check parts
Press "▼" and "▲" buttons to select the
"CHECK PARTS" in the "PROJECT
MENU" interface, and press the "OK"
button to enter the interface. The interfaca
display is as follows:
CHECK PARTS
SV1
SV2
Pump
Heat1
Heat2
BACK
The screen displays conditions of all parts;
users can press "BACK" button to exit after
confirming.
◆
Controller select
This function is reserved,Some special
models have this function.
Press "▼" and "▲" buttons to select the
"CONTROLLER SELECT" in the "PROJECT
MENU" interface, and press the "OK" button
to enter the interface. The interfaca display is
as follows:
CONTROLLER SELECT
OK
Operation instructions:
When select modbus "YES",and press "OK"
button to acess the function.User can use a
OFF
host computer to communicate with the wried
OFF
controller by modbus protocol,and these
operations on the wired controller as
OFF
"Power-ON/OFF","Setting Mode","Timer"and
OFF
"Setting temperature" are invalid.
OFF
3.6 Setting SERVICE MENU
◆
Entering the password:
Select "SERVICE MENU", and press the "OK"
button to enter the interface. The screen
prompts the user to enter the password, as
shown below:
17
MODBUS:
NO
V.1