EAS ELECTRIC ECH R32 Serie Manual De Instalación Y Usuario página 82

SET ADDRESS
00
OK
The set address range is 00 to 15.
Press the "▲" and "▼" buttons to select the
desired values.If there is no subsequent
operation in 60s, or press "OK" button the
setting is saved automatically, and the system
returns to the home page.Press the "BACK"
button to cancel the setting and return to
the previous interface.
The units only have one main control wired
remote controller(the default address 00),
and other address(address 01-15)must be
seted as monitor wired remote controller.
When set address "00" and press "OK"
button,the wired remote controller will
enter the interface as follows:
When set address "01-15" and press "OK"
button,the wired remote controller will enter
the interface as follows:
MON 10：35A
26
20/11/2017
ON COOL Tws
Tw
PRESS MENU TO QUERY STATUS
60%
45%
When the wired controller is unlockd press
"MENU" botton to enter the "SERVICE
MENU" function.
3.11 Upper Computer
Communication Function
1) The home page displays the content below
during communication with the upper
computer: Communication between the wired
controller and the upper computer,the icon
" " will be displayed on the home page
interface.
2) If the outdoor main control board is in the
remote ON/OFF control mode and the wired
controller sends an alarm and the icon "
flash, the current alarm page displays:
Remote ON/OFF Control Mode. In this case,
the network control of upper computer is
invalid, and the wired controller can query the
system status only and cannot send out
control information.
MON 10:35 A
ONLINE
55
C 16
UNITES
55
C
ERROR
E1
V.1
"