ASSEMBLY BACK REST
1. Insert the two clips (per back rest) between the 2nd
and 3rd plank, with its opening pointing towards the
floor.
2. Hold the back rest so that the holes in the flat parts
are situated just below the holes in the clips. Two
people are needed for this part of assembly. Put the
bolts through the hole in the backrest and tighten then
in the clips.
4. Repeat these actions for all back rests.
6
assembly back rest - inumbra - inumbrina
3. Firmly tighten the bolts to prevent them from
loosening spontaneously. Repeat these operations for
every back rest.