Waste Management; General Description - GYS GYSFLASH 1.12 PL Manual Del Usuario

• Always ensure the Red clamp is connected to the «+» battery
terminal first. If it is necessary to connect the black clamp to the
vehicle chassis, make sure it is a safe distance from the battery and
the fuel/exhaust pipe. The charger must be connected to the mains.
• After charging, disconnect the charger from the mains, then
disconnect the negative clamp from the car body and then disconnect
the positive clamp from the battery, in this order.
Connection :
• Class II device
• The connection to the power supply must be carried out in
compliance with national standards.
Maintenance :
• If the power cable is damaged, it must be replaced by the
manufacturer, its after sales or by an equally qualified person to
prevent any accidents.
Regulations :
• The Machine is compliant with European directives.
• The declaration of conformity is available on our website.
• EAEC Conformity marking (Eurasian Economic Community).

Waste management:

• This product should be disposed of at an appropriate recycling
facility. Do not throw away in a household bin.

GENERAL DESCRIPTION

The GYSFLASH 1.12 PL is designed to charge lead-acid batteries (Gel, AGM, Liquid, ...) and lithium of the Lithium Iron Phosphate
(LFP / LiFePO4).commonly used for motorcycles, water scooters and many other small vehicles.
This charger is suited for the charge of:
- Lead-acid batteries 12 V (6 elements in series of 2V) from 2 Ah to 32 Ah, and up to 100 Ah for charge support.
- The charge 12V LFP batteries (4 cells in series of 3V) from 0.5 Ah to 20 Ah, and up to 50 Ah for charge support.
START UP
1. Connect the charger to the battery using the proper accessory (clamps, lugs, etc...).
2. Plug the charger to the mains (single phase 220-240Vac 50-60Hz).
3. Select the mode by pressing the
4. During the charge, the device indicates the charge progress. When indicator
Once indicator stays on, the battery is fully charged.
5. The charge can be interrupted at any time by unplugging the mains plug or pressing the
6. After the charge, disconnect the charger from the mains, then disconnect the clamps from the battery.
8
GYSFLASH 1.12 PL
button. After roughly five seconds, the charge starts automatically.
blinks, the battery is ready to start the vehicle.
button.
EN