Waste Management; Standard Mode - GYS STARTRONIC 12/24 V Manual De Instrucciones

• EAEC Conformity marking (Eurasian Economic Community).

Waste management:

• This product should be disposed of at an appropriate recycling
facility. Do not dispose of in a domestic bin.
OFF

STANDARD MODE

Emergency start function for petrol or diesel vehicles equipped with a 12V or 24V battery.
To start a vehicle, please process as follows:
1
2
3
4
5
ON
6
STEP 3 : THE DEVICE ACTIVATES THE 12V MODE FOR A 24V BATTERY?
The battery voltage is probably inferior to 15V. In that event press the
charging of the device. When the 14V stops blinking, push the ON / OFF button for a while (~4 sec.), the
STARTRONIC will automatically switch to 24V mode.
8
STARTRONIC 12/24 V
Make sure that the vehicle's engine is off, handbrake on.
Switch off all electrical and electronic machines in the vehicle (AC, ventilation, radio, lights,
etc).
Make sure that the vehicle's battery terminals are clean, grease and corrosion free.
Connect the red clamp to the battery's (+) and the black clamp to the battery's (-).
The device switches on automatically and detects the battery voltage (12 or 24V). If the bat-
tery voltage is higher than 15V, the device will set itself to 24V mode. If the battery voltage is
lower than 15V, the device will set itself to 12V mode.
The voltage indicators display the voltage of the vehicle's battery.
Press the on/off button (key 2) before starting the charge of the STARTRONIC.
Full charge takes approximately 2 minutes. During the charge, the voltage indicators will blink
until they reach 14V/28V.
When the 14V/28V indicator stops blinking, the device is charged and ready to start your
vehicle.
Start your engine.
When the engine starts, remove the clamps from the vehicle.
ON/OFF button to resume the
EN