Installation Instructions - Festo CPX-FB14 Breve Descripción

3

Installation instructions

3.1 Fitting
Field bus node CPX-FB14 is mounted in a manifold sub-
base of the CPX terminal.
Screws, tightening
1
torque 0.9...1.1 Nm
2 Field bus node
CPX-FB14
Contact rails
3
4 Manifold block
Dismantling
Remove the screws and carefully lift up the field bus
S
node.
Fitting
1. Check the seal and sealing surfaces and refit the sub-
base.
2. Place the screws so that the self-cutting threads are
used. Tighten the screws by hand in diagonally oppo-
site sequence. Tightening torque 0.9...1.1 Nm
Festo CPX-FB14 0206NH English
1
2
3
4
17