Charge State Indicator; Items Supplied - Hilti SL 2-A12 Manual Del Usuario

SL 2-A22
Use only Hilti Li­ion batteries of the B 22 series with this product.
▶ Use only the Hilti battery chargers of the C4/36 series for charging these
batteries.

3.3 Charge state indicator

Lightly press (no more than until resistance is perceptible) either of the
battery release buttons to check the charge state of the Li­ion battery.
Status
4 LEDs light up.
3 LEDs light up.
2 LEDs light up.
1 LED lights up.
1 LED flashes.
Note
If the LEDs of the charge state indicator flash, follow the instructions in
the 'Troubleshooting' section.
3.4 3-mode switch
Use the 3-mode switch to set the brightness.
Status
Press once
Press twice
Press three times

3.5 Items supplied

Cordless lamp, operating instructions.
Other system products approved for use with this product can be found at
your local Hilti Center or online at: www.hilti.com
4 English
Printed: 21.04.2017 | Doc-Nr: PUB / 5346559 / 000 / 00
Meaning
• Charge state: 75 % to 100 %
• Charge state: 50 % to 75 %
• Charge state: 25 % to 50 %
• Charge state: 10 % to 25 %
• Charge state: < 10 %
Meaning
• The lamp lights with maximum
brightness.
• The lamp lights with medium
brightness.
• The lamp is off.