BMV 5 Serie Manual Del Usuario página 121

On all other vehicles
Connect branch D5, 1-pin blade terminal contact, black wire, at PIN9 of control unit connector X1171. If PIN9 is
already used, the contact part of branch D5 must be cut off and the black wire in the package area of the ABS plug
connector must be soldered to the wire from PIN9 and insulated accordingly.
Connect D6, 1-pin blade terminal contact, yellow wire, at PIN42 of control unit connector X1171.
If PIN42 is already used, the contact part of branch D6 must be cut off and the yellow wire must be soldered to the
wire from PIN42 and insulated in the package area of the ABS plug connector.
Reassemble control unit connector X1171 and reconnect to ABS control unit (67).
Install ABS control unit (67) and secure auxiliary wiring harness for navigation D with cable straps (32).
Continue with Section 2.6
2-103