Installatiproduction Of Auxiliary Wiring Harness For Navigatiproduction Production Vehicles From Productiproduction Date - BMV 5 Serie Manual Del Usuario

2.4 Installation of Auxiliary Wiring Harness for Navigation on Vehicles
from Production Date 9/98
Notes
Refer to general information as well as safety notes in Section 1.
Open out fold-out page! (Page 2-99)
Fig. A
This figure shows the layout of the auxiliary wiring harness for navigation C on vehicles from production date 9/98.
Fig. B
Fit retaining clip (7) with connected branch A15 from on-board monitor wiring harness A in mounting bracket for
video module at front (17).
Clip branch C1, black 6-pin pin housing from auxiliary wiring harness for navigation C, to branch A15 from on-board
monitor wiring harness A.
Route auxiliary wiring harness for navigation C along the closing panel to right-hand side section and from here to
leadthrough grommet at top right of luggage compartment (see Fig. A).
Secure auxiliary wiring harness for navigation C with cable straps (32).
Fig. C
Route auxiliary wiring harness for navigation C together with branches C2, C3, C4, C5 and C6 through leadthrough
grommet (61) into vehicle interior and along the right-hand main wiring loom to the place of installation of the light
module in the right-hand A-pillar (see Fig. A) and secure with cable straps (32).
Fig. D
Remove light module (62), disconnect black 54-pin socket housing X10117 from light module (62) and open.
Connect branch C2, 1-pin blade terminal contact, white/yellow wire, at PIN38 of black 54-pin
socket housing X10117.
Close black socket housing X10117, connect and reinstall light module (62).
If necessary, tie back excess length of auxiliary wiring harness for navigation C before branch C2 .
Fig. E
Disconnect black 42-pin plug connector X1170 from ABS hydraulic unit (63) at front right of engine compartment,
open and check whether PIN18 and PIN35 are used.
If PIN18 and PIN35 are not used, only Fig. F, Fig. J and Fig. K will be required for the installation.
If PIN18 and PIN35 are used, only Fig. G and Fig. L will be required for the installation.
If PIN18 is used and PIN35 is not used, only Fig. H, Fig. J, Fig. K and Fig. L will be required for the installation.
If PIN18 is not used and PIN35 is used, only Fig. H, Fig. J, Fig. K and Fig. L will be required for the installation.
Fig. F
This figure shows the cable layout for the case that PIN18 and PIN35 of X1170 are not used
a
The cover is to be removed from the control unit box on the right in the engine compartment before
installing the cable.
c
Insulate branches C3 and C4 of auxiliary wiring harness for navigation C, with shrink-fit tubing as described under
Fig. J and tie back in the area of the front right sill (rocker panel).
Route branches C5 and C6 of auxiliary wiring harness for navigation C, as described under Fig. J and Fig. K ,
through the leadthrough grommet in the bulkhead, front right, into the control unit box and from here further to
the ABS hydraulic unit and connect to black 42-pin plug connector X1170 of the ABS hydraulic unit.
2-79