1.
Important Information
Intended for use in BMW dealership network only.
Specialised knowledge is required.
Installation time required 7 .0 hours
The installation time may vary depending on the condition and equipment of the vehicle.
a
The on-board monitor and navigation installation kit is only suitable for vehicles equipped with option 555,
high on-board computer.
Target group
These installation instructions are intended for specialist personnel trained in BMW passenger cars and who
independently carry out all maintenance, repair, installation and readjustment jobs on passenger cars.
All jobs are to be carried out with the aid of valid BMW
– Repair instructions
– Schematic circuit diagrams
– Maintenance manuals
– Working instructions
– Diagnosis manuals
in rational order with the specified tools (special tools) and in compliance with valid health and safety regulations.
Installation notes
Knowledge of vehicle electrical systems is required
All jobs are referred to left-hand drive vehicles, the same procedure should be followed on right-hand drive vehicles.
a
The finisher for the on-board monitor is dependent on the equipment variant and must be ordered separately in
accordance with the electronic parts catalogue (EPC).
The control line for the on-board monitor radio/CD changer is not included in the installation kit and must be ordered
separately in accordance with the electronic parts catalogue (EPC) for vehicles with CD changer and without
DSP amplifier.
The trim panel at the rear left of the luggage compartment in front of the navigation computer is not included in the
installation kit and must be ordered separately in accordance with the electronic parts catalogue (EPC)
corresponding to the equipment status of the vehicle.
Safety notes
Particular care must be taken when installing cables/lines to ensure they are not kinked, bent or damaged.
Additionally installed cables/lines must be secured with cable ties.
Necessary tools and aids
Set of 1/4 inch socket wrenches
Set of screwdrivers for cross-head screws
Inspection lamp
Side cutter
Silicon
Subject to technical modifications
1-2
c
Set of Torx socket wrenches
Set of screwdrivers for slotted-head screws
Multipurpose knife
Screwdriver for cross-head screws, short
Hot air blower
c