Impact Drilling - Casals CNPD16REAK Manual Del Usuario

- Always check the workpiece before operation and remove
when any obstructions such as nails, staples, screws, string, rags,
cloths and other debris.
- Check the position of power cables before commencing
work ensuring they are well away from the work
es are
- Keep hands and other body parts well away from the work
mpany area whist the tool is in use.
ad to
ead to Product description and Specifications
mage
Description
oving
aught 1. Drill chuck
2. Drilling/Impact Drilling Selector
dust 3. Cooling vents
e are 4. Depth stop
n can 5. Auxiliary handle
6. Speed regulator control
orked 7. Rotation direction switch
ree to 8. Handle
9. Start-up switch
while 10. Locking button
of dust
rfaces
t that Instructions for use
ations. Before use:
stone, - Make sure that all the product's packaging has been
Wear removed.
e with - Ensure that the voltage indicated on the rating label
matches the mains voltage before plugging in the appliance.
gas or - Prepare the appliance according to the function you wish
to use:
on on
effect Auxiliary Operation
- When working always use the auxiliary handle (5).
those - The depth can be set with the depth stop (4). Thereby
loosen the winged screw by turning the auxiliary handle (5)
use. counter clockwise.
operly - Set de required drilling depth.
- Tighten the winged screw by turning the auxiliary handle
mables (5) clockwise.
y.
Insert a drill bit:
- To open the drill's chuck, whilst completely switched off,
rvised take firm hold of the back part of the chuck and turn the front
part of the chuck counter clockwise.
es. - Insert the drill bit, screwdriver bit, or other tool/accessory
ds in a required for the task, into the chuck. In order to obtain a
efects secure fastening of the bit, insert the bit as far as you can
oblem into the chuck. Take firm hold of the back part of the chuck
Repair and turn the front part of the chuck clockwise until it is firmly
closed.
- In order to remove accessories from the chuck, follow the
same steps as indicated previously but in reverse order.
Screwing, drilling/unscrewing:
- To drill or screw, ALWAYS have the direction set to
clockwise (CW).
- To unscrew, set the direction to counter clockwise (CCW).
- The appliance should not be in use when changing the
screwing direction.
Rotation direction change:
- Do not change the direction of the rotation whilst the tool
motor is in operation.
- The appliance has a selector (7), which allows the direction
of rotation to be changed
Electronic speed control:
- The speed of the appliance can be regulated by using the
speed regulator control (6). This function is very useful, as it
makes it possible to adapt the speed of the appliance to the
type of work that needs to be done.
- If the appliance works continuously at low speed, working
life of the appliance will be reduced considerably.
Drilling, Driving and Impact Drilling
Drilling and driving
- Shift the selector (2) until the arrow on the selector points
to ( ).

Impact drilling

- Shift the selector (2) until the arrow on the selector points
to ( ).
Use:
- Connect the appliance to the mains.
- Turn the appliance on, by using the on/off button
- Select the appliance function desired.
- Select the desired speed.
Locking button:
- To activate this function press button (10) while holding
down the run button.
- To deactivate this function press the run button right down.
Once you have finished using the appliance:
- Stop the appliance by releasing the on/off switch.
Cleaning
- Disconnect the appliance from the mains and allow it to
cool before undertaking any cleaning task.
- Clean the electrical equipment and the mains connection
with a damp cloth and dry. DO NOT IMMERSE IN WATER
OR ANY OTHER LIQUID.
5