ESYLUX PD-C360i/24 DUODIMplus-FM Manual De Instrucciones página 14

• The greater the installation height, the wider the range, but also the
lower the detector's level of sensitivity.
• Movements diagonal to the detector are ideal for triggering the device
(a direct and head-on approach makes it more difficult for the device
to detect movement and the range is thus significantly reduced).
GB
• The detector should be positioned according to spatial conditions
and requirements.
• Ensure that the detector has a clear line of sight, as infrared beams
cannot penetrate solid objects.
The presence detector features two separate DIMMER light channels.
Both light channels are synchronised (C1 = C2) in the factory settings.
Light channel C2 can be adjusted after light channel C1.
Information on how to position and align the detector (see fig. 2):
The detector should be mounted in a central position between the strip lights.
Channel 1 must be oriented towards the wall side (dark side of the room)
and channel 2 must be oriented towards the window side (bright side
of the room).
ESYLUX PD-C360i/24 DUODIMplus series presence detectors consist
of a power and a sensor section. Install the power section in the required
position (fig. 3) and connect the presence detector as shown in the circuit
diagram (fig. 4).
Fig. 4 Master / slave connection for presence detectors: you can connect a max.
of 10 slave devices to one master device. Ensure that the total length of
the cable used to connect the master to the furthest slave device does not
exceed 100 m, as this may result in switching errors, depending on the
type of installation.
14
You can adjust the detector's settings using the DIP switches on the
back of the sensor (see the "DIP switch" section in chapter 6).
This must be done before the device is activated. Plug the sensor
section into the power section and gently screw in place.
4 • START-UP
Connect the power supply
• This will initiate a warm-up phase of approximately 25 seconds.
The red (light channel 1 = C1), the green (light channel 2 = C2) and the
blue LEDs will flash alternately. The connected lighting will be switched
on during this time.
The detectors are preset to factory setting P1 / remote control and are
therefore immediately ready for use after the warm-up phase.
Overview of the factory settings (DIP switch 3)
Light value for light channel 1
Light value for light channel 2
Time setting for light channel 1 + 2
Time setting for HVAC channel
Mode
Orientation light
Orientation light value
Factory setting P1 Factory setting P2
400 lux 200 lux
C1 = C2 C1 = C2
5 minutes 2 minutes
30 minutes 30 minutes
fully automatic fully automatic
off on
10 % 30 %